Installation and repair of walk-in cold rooms and freezer rooms for Hout Bay restaurants, butchers, delis and food producers.
A cold room is a system, not a box. Panel thickness, insulation condition, door seals, evaporator selection, defrost strategy and the condensing unit's location all determine whether it holds temperature on a hot February afternoon with the door opening every few minutes.
We install new rooms and repair existing ones, from a single panel replacement to a full condensing unit change. For existing rooms we start with a temperature and pressure survey: how the room performs under real load tells you more than any nameplate rating.
[ 01 ] Signs it needs attention
- Room not holding temperature during service, or after door openings
- Ice on the ceiling, floor or evaporator, or water pooling
- Condensing unit short-cycling or tripping
- Door not sealing, or a heater failed and the door frozen shut
- Planning a new kitchen, butchery or deli and needing a room designed
- An old room with failing panels or an undersized unit
[ 02 ] What the work covers
- New cold room and freezer room design and installation
- Panel, door and seal replacement
- Condensing unit and evaporator replacement or repair
- Defrost, drain and door heater repairs
- Controls, temperature alarms and monitoring
- Load testing and commissioning against the room's intended use
[ 03 ] The coastal factor
Condensing units are often pushed into a service yard or onto a roof where salt air and heat both work against them. We specify coated coils and corrosion-resistant housings for coastal installs, and make sure there is real airflow around the unit rather than a decorative gap.
Corrosion guide