Repairs to commercial ice machines that have stopped producing, are producing cloudy or soft ice, or are leaking and noisy.
An ice machine that half-works is worse than one that stops, because nobody notices until service. Production drops are usually water quality, scale on the evaporator, a failing water valve, a dirty condenser or a refrigerant fault.
We diagnose production rate, cycle time, water flow and condenser condition, then clean, repair or replace what is actually causing the shortfall. Where water hardness is the underlying problem, we will say so rather than simply descaling every few months.
[ 01 ] Signs it needs attention
- No ice, or ice production far below the machine's rating
- Cloudy, soft or wet ice that clumps in the bin
- Machine cycling repeatedly or stopping mid-harvest
- Water leaking onto the floor or into the bin
- Loud compressor or fan noise
- Scale build-up visible on the evaporator plate
[ 02 ] What the work covers
- Cycle and production diagnosis with measured timings
- Descaling and sanitising of evaporator and water circuit
- Water inlet valve, float valve and pump repairs
- Condenser cleaning and airflow correction
- Refrigerant leak detection, repair and recharge
- Control board, sensor and harvest mechanism repairs
[ 03 ] The coastal factor
Salt air accelerates corrosion on ice machine casings and condenser coils, and coastal humidity makes a damp bin more likely. Regular condenser cleaning and a dry, ventilated position do more for reliability than any additive.
Corrosion guide